How to deal with Ariston White vomiting yellow, oil seepage, blackening of gaps

The mainstream products are white marble, such as White Jade marble, Volakas white marble, Oriental White Marble, Cararra White marble, Ariston White Marble, and Staturario White Marble, Calacatta White Marble, etc..

Oriental White:

Volakas White:

Cararra White:

Ariston White:

Among them, Ariston White is very pure white, inlaid with very pure gray, the texture is natural and natural, making people unable to withstand temptation. It is often used for TV background wall, bathroom wall, and ground decoration, because of its quiet, Elegant, soft and rustic light luxury decoration style, deeply loved by modern young people.

However, due to the delicate texture and light color, it also brings a lot of confusion in the renovation and treatment: yellowing, blackening, not easy to shine, and obvious refraction after polishing the wall.

According to the construction experience in recent years, talk about the solutions to the common problems in the repair and renovation of Ariston White, and share the experience to avoid repeating the same mistakes.

Causes of vomiting:

　　 The surface of the board is damp or contaminated with ferrous materials, commonly known as "rust".

　　 Rust is due to the high iron content of Yashibai, so be sure to choose colorless oil-based waterproof products BT-6002/BT-9002 and other six-sided protection to prevent diseases.

　　The rust condition can be removed by using the special marble descaling agent R96, D72, etc.

　　Adhesives are oily and yellow and require special degreasing cream to cure them.

　　 This kind of phenomenon is mainly because the selected adhesive contains solvent, the sheet is loose, causing penetration and yellowing, affecting the appearance.

　　 Therefore, high-quality adhesives should be used when installing white stone. If possible, unsaturated resin adhesives should not be used, as they contain styrene and are easy to penetrate.

　　 Solvent-free AB two-component epoxy jade glue can be preferred, not only without the trouble of oil penetration and discoloration, but also the delicate texture and close color.

　　If you must use marble glue, you should apply oily protective agent BT-9002 to the cracks in advance to prevent the occurrence of oily black seams.

　　Refraction reasons:

　　Yashibai has a special structure, showing a cloud crystal state. The large boards are usually scraped after being processed by the surface glue and polished under high pressure and high speed. The brightness is very good.

　　 However, when doing wall decoration, due to the insufficient speed and pressure of the grinding machine, it often causes refraction at the grinding place.

  Solution:

　　 Add water grinding as much as possible from the beginning if you must dry grinding, after dry grinding 3#, connect A981 crystal surface agent, locally harden, then dry grinding 4#5# glazing, and finally A982 crystal face paste is added to restore the light.

　　It should be noted that if the mill speed exceeds 6000rpm, 4#/5# dry milling will cause black hair (burnt plate) when improperly controlled. If necessary, white neutral polishing powder (M3113) and water polishing can be selected to restore.

  to sum up:

Yashibai is simple and low-key and luxurious, but it should be well protected with oil on six sides during stone care. Try to use epoxy-type solvent-free adhesives. When grinding and polishing, water grinding is the top. Try to use neutral marble polishing powder to avoid burnt board fade.

　　White plate is not easy to care for, soft and easy to pollute, it is best to choose fluorosilicone stone protective agent.